Yamaha SU700 - Manual (Page 274)

Chapter 10 J
obs
274 Chapter 10 Jobs
Basic Information
●
Resampling is always carried out at 44.1 kHz sampling frequency and 16-bit reso-
lution. The new sample is always monaural. (You cannot change these sampling
conditions.)
●
When carrying out this job, you are prompted to set the GAIN and the L/R channel
mode.
■
The GAIN setting determines the gain applied to the source waveform; positive
values will produce a “louder” waveform (higher amplitude) at the destination
side, while negative values produce a “quieter” waveform (lower amplitude) at
the destination side. You can set the value from
-12 to +12 . The default gain is
+00 .
■ The L/R channel mode determines how the source sample’s channels are
handled. You can select any of three settings. Note that regardless of setting, the
result is always a monaural sample.
L+R Resample the mix of the source sample’s left and right out-
puts. (This is the default.)
MONO L Resample the source sample’s left output only.
MONO R Resample the source sample’s right output only.
●
While this job is selected, the track meters operate as a two-channel horizontal
level meter, just as during normal sampling recording. The meter grows to the right
as the level increases, and the word
CLIP appears if the level goes too high. The up-
per part of the level meter indicates the recording level for the right channel; the
lower part of the meter indicates the level for the left channel.
●
For the source track, you can use any nonempty sample track (LOOP, COMPOSED
LOOP, or FREE) track, or you can use the AUDIO IN track to record direct analog
audio input. If you wish to select AUDIO IN, however, the audio input source (the
AUDIO IN parameter in the SYSTEM | SETUP job) must be set to MIC or LINE (
→
p.302).
●
For the destination track, you can use any sample track (with the exception of the
source track itself).
●
This job does not change any sequence data already existing on the destination
track.
●
When working at this job, you can listen to the sound of the source track at any
time by pressing the pad. While resampling is in progress, the sound will be au-
dible on speakers or headphone. Note that you cannot adjust knob settings
while working within this job, however; you must set the knob values before
you enter the job.
●
The new sample is not associated with the destination track until you complete the
resampling process (at step 10 below). Canceling the job at any time prior to
completion will restore the destination track to its original state.