Yamaha SU700 - Manual (Page 236)

Chapter 10 J
obs
236 Chapter 10 Jobs
TRACK SET | SETUP
Use to: Set various playback parameters for each track, or to view current set-
tings.
●
Parameters are as follows. See below for a detailed explanation of each setting.
BPM TRACKING Determines how playback reacts to changes in tempo
(BPM). Applies to sample tracks only (cannot be set for AU-
DIO IN or MASTER tracks).
LOOP LENGTH Sets the length of the loop generated by the track. Applies to
LOOP tracks and COMPOSED LOOP tracks only.
OUTPUT TO Selects the output destination for the track. Applies to
sample tracks only. (Available only if optional AIEB1 board
is installed.)
LFO WAVE Selects the waveform for the track’s low-frequency oscillator.
Procedure
Be sure that you have selected the song containing the track(s) that you want to set up.
1. Press TRACK SET | SETUP to enter this job.
2. Turn the [mike9]dial to select the parameter you are interested in: BPM TRACKING,
LOOP LENGTH, OUTPUT TO, or LFO WAVE. Then press [OK].
▼ The screen moves to the corresponding setup screen, and shows the value for the
currently selected track. The bank number and meter bracket indicate the currently
selected track (If you were working on a track for which this setting is not available,
then the selection will change to the nearest supporting track.)
3. If necessary, change the track selection by pressing the appropriate bank selector and
pad.
4. Turn the dial to change the setting.
5. Repeat steps 3 and 4 as necessary to set values on multiple tracks. When you have
finished making settings, press [OK] once to return to the main display, or press
[CANCEL] once to return to step 2.