Yamaha DSP5D - Manual (Page 186)

SCENE function
186
PM5D/PM5D-RH V2 / DSP5D Owner’s Manual Reference section
Here you can make settings for the Tracking Recall func-
tion, which adds a specified offset value to the value of each
fader when you recall a scene.
A TRACKING RECALL ENABLED/DISABLED
Enables/disables the Tracking Recall function.
Hint
The settings in the TRACKING RECALL screen apply to all
scenes.
B DISPLAY SELECT
These buttons select the type of channels that are
shown in the TRACKING RECALL screen; either
INPUT (input channels) or OUTPUT (output
channels).
C SET ALL
This button enables Tracking Recall for all channels
(including channels not currently shown in the screen).
D CLEAR ALL
This button disables Tracking Recall for all channels
(including channels not currently shown in the screen).
E OFFSET LOCK
If this button is on, the sliders of all channels (includ-
ing channels not currently shown in the screen) will be
grayed-out, and you will be unable to edit the offset
value.
F ON (Tracking On)
These buttons enable/disable tracking for each chan-
nel. If the TRACKING RECALL ENABLED/
DISABLED button is set to ENABLED, tracking is
enabled on channels for which this button is ON.
Note
If OFFSET LOCK ( 5 ) is off, turning this button on will reset
the tracking offset of the corresponding channel to 0 dB. If in
this state you operate the fader of the corresponding channel,
the relative amount of fader movement from the point at which
this button was turned on will be memorized as the tracking
offset. You can then turn OFFSET LOCK on to lock the offset.
This offset value will be added whenever you subsequently
recall a scene.
G Tracking offset
Here you can specify the offset value applied to each
channel if tracking is enabled. The range is ±15 dB.
While OFFSET LOCK (
5 ) is off, operating the panel
faders will cause these values to change as well; how-
ever, adjusting the offset values in the screen will not
cause the panel faders to move.
TRACKING RECALL screen
TRACKING RECALL
3 4
2 1 5
7
6