Yamaha DSP5D - Manual (Page 236)

MON/CUE function
236
PM5D/PM5D-RH V2 / DSP5D Owner’s Manual Reference section
’Here you can make settings and perform operations
related to the internal oscillator.
A OSC ON/OFF (Oscillator on/off)
Turns the Oscillator on/off. This is linked with the
OSCILLATOR [ON] switch of the top panel.
B OSC MODE (Oscillator mode)
These buttons select the waveform or type of noise pro-
duced by the oscillator.
SINE WAVE 1CH . Sine wave x 1 channel
SINE WAVE 2CH . Sine wave x 2 channels
PINK NOISE . . . . . Pink noise
BURST NOISE . . . . Burst noise (repeated output of
pink noise)
C PARAMETERS
Here you can set various items according to the selec-
tion in (
2 ).
• If SINE WAVE 1CH is selected
• If SINE WAVE 2CH is selected
• If PINK NOISE is selected
• If BURST NOISE is selected
D LEVEL
This knob adjusts the output level of the oscillator. The
range is –96 dB to 0 dB. The level meter beside the
knob indicates the output level.
E FREQ (Frequency)
This knob specifies the frequency of the sine wave pro-
duced by the oscillator. The range is 20 Hz–20 kHz (the
current setting is shown in the numerical box below).
You can use the 10 kHz /1 kHz / 100 Hz buttons to
select a preset frequency.
Hint
If SINE WAVE 2CH is selected, you can specify the level and
frequency of each channel independently.
F HPF (High Pass Filter)
G LPF (Low Pass Filter)
Here you can make settings for the HPF/LPF through
which the pink noise or burst noise is sent. The knob
above sets the cutoff frequency (20 Hz–20 kHz), and
the button below switches the filter on/off.
OSCILLATOR screen
OSCILLATOR
1
3
2
5 4
5 4 5 4
6 7 4
6 7 4 9 8