Yamaha DSP5D - Manual (Page 22)

2
Top, front, and rear panels
22
PM5D/PM5D-RH V2 / DSP5D Owner’s Manual Operating section
DSP5D rear panel
A Cooling fan vents
These are the vents for the DSP5D’s internal cooling
fans (two locations). When placing the unit, take care
that these vents are not obstructed.
B FAN switch
This switches the rotational speed of the DSP5D’s
internal cooling fans between HIGH and LOW.
For normal use, set this to LOW. However if the
DSP5D is in a location of high temperature or is out-
side in direct sunlight, set this to HIGH. You should
also set this to HIGH if you feel that the panel is
warmer than usual.
C Mode switch
This switch is used when initializing the settings of
internal memory, when updating the firmware in the
future, and when setting the machine ID number.
D POWER LED
This will light if power is being supplied to the DSP5D.
E Grounding screw
For safe operation, be sure that the DSP5D is correctly
grounded. The included power cable has a three-pin
plug, and if the AC outlet is grounded, the DSP5D will
be grounded appropriately. If the AC outlet you’re
using is not grounded, you must be sure to connect
this screw to a valid electrical ground. Correct ground-
ing will effectively eliminate noises such as hum and
interference.
FAN
HIGH LOW
POWER
FAN
HIGH LOW
POWER
1
2 3 4
5