Yamaha DSP5D - Manual (Page 308)

PAN/ROUTING function
308
PM5D/PM5D-RH V2 / DSP5D Owner’s Manual Reference section
D TO ST (To stereo)
If this button is on, the corresponding input channel is
assigned to the STEREO bus. This is linked with the
TO ST button of the CH to MIX screen (PAN/ROUT-
ING function).
E DIRECT
If this button is on, the signal of the corresponding
input channel will be sent to the output port selected as
the direct output. This is linked with the DIRECT OUT
ON/OFF button in the INSERT/DIRECT OUT POINT
screen (IN PATCH function).
F Output port
This area indicates the output port that is patched in
the DIRECT OUT PATCH screen (INPUT PATCH
function) to the direct output of this input channel
G ALL STEREO
Clicking this button enables the assignment of all input
channels to the STEREO bus.
H ALL BUS
Clicking this button enables the assignment of all input
channels to FIXED-type MIX buses.
I ALL CLEAR
Clicking this button cancels all assignments in the FIX
ASSIGN VIEW screen.
J SURROUND MODE
This indicates the currently selected surround mode.
Here you can make settings for LCR mode, which allows
three-channel playback by adding a CENTER channel to
the L/R channels of the STEREO bus.
Except for the fact that the send-sources are input chan-
nels, the display and operations are the same as in the
MATRIX/ST function LCR screen. Refer to p.267.
8 9
J
7
LCR screen
LCR