Yamaha DSP5D - Manual (Page 259)

PM5D/PM5D-RH V2 / DSP5D Owner’s Manual Reference section
259
Information shown
in the display
Function
menu
Global
functions
Output
functions
Input
functions
Appendices
D SET BY CUE (Assign by [CUE] key)
This specifies whether the [CUE] key will be used to
make/cancel DCA group assignments. While the DCA
group SET BY CUE button is on, pressing the [CUE]
key of a channel that can be assigned to the corre-
sponding group will assign the channel to the group.
(Press the [CUE] key once again to cancel the
assignment.)
Hint
• The SET BY CUE button can be turned on for only one DCA
group. This is automatically turned off when you change
screens or turn off the power.
• To turn on SET BY CUE from the panel, press the ASSIGN
MODE [DCA] key and then turn on the DCA group 7/8
[CUE] key.
E CLEAR
This button clears all output channels assigned to that
DCA group.
F MUTE
These buttons switch muting on/off for DCA groups 7/
8. They are linked with DCA [MUTE] keys 7/8 in the
DCA strip of the panel.
G DCA faders
These faders adjust the levels of DCA groups 7/8. They
are linked with DCA faders 7/8 in the DCA strip.
H CUE
These buttons cue-monitor DCA groups 7/8. They are
linked with DCA [CUE] keys 7/8 in the DCA strip of
the panel.
I DCA LEVEL SET
Use the following two buttons to operate DCA groups
7/8 together.
• ALL NOMINAL
Clicking this button will move DCA faders 7/8 to nom-
inal level (0 dB).
• ALL MINIMUM
Clicking this button will move DCA faders 7/8 to the
–
∞ dB position.
Here you can specify the output channels that will be
assigned to mute groups 1–8. Muting can be switched on/
off together for channels assigned to the same mute group.
A Mute group
This area shows the mute group number. The number
corresponding to the grid where the cursor is located is
highlighted.
B MUTE (Mute master)
These buttons switch muting on/off for each mute
group. These buttons are linked with the SCENE
MEMORY [1]–[8] keys of the panel (if the MUTE
MASTER button is On in the constantly-shown area at
the bottom of the display).
Hint
When you turn muting on, channels belonging to that mute
group will behave just as though their panel [ON] key had
been turned off; no signal will be output. During this time, the
panel [ON] key LED will blink.
C Grid
This grid lets you assign output channels (horizontal
rows) to mute groups (vertical columns). Currently-
patched grids are indicated by a symbol. Move the
cursor to the desired grid and press the [ENTER] key
(or click) to set/cancel the assignment.
5 4
6
8
7
9
MUTE GROUP ASSIGN screen
MUTE GROUP ASSIGN
3 2 1
4