Yamaha DSP5D User Manual
Page 323
PM5D/PM5D-RH V2 / DSP5D Owner’s Manual
Reference section
323
Information shown
in the display
Function
menu
Global
functions
Output
functions
Input
functions
Appendices
❏ COMPANDER HARD (COMP.(H))
❏ COMPANDER SOFT (COMP.(S))
The hard and soft companders combine the effects of the compressor, expander and limiter.
The companders function differently at the following levels:
1
0 dB and higher . . . . . . . . . . . . . . . . . . Functions as a limiter.
2
Exceeding the threshold . . . . . . . . . . Functions as a compressor.
3
Below the threshold and width . . . . Functions as an expander.
The hard compander has an expansion ratio of 5:1, while the soft compander has an expansion ratio of 1.5:1. The expander is
essentially turned off when the width is set to maximum. The compressor has a fixed knee setting of 2.
* The gain is automatically adjusted according to the ratio and threshold values, and can be increased by up to 18 dB.
* The OUT GAIN parameter enables you to compensate for the overall level change caused by the compression and expan-
sion processes.
Parameter
Range
Description
THRESHOLD (dB)
–54 to 0 (55 points)
This determines the level at which compression is applied.
RATIO
1.0:1, 1.1:1, 1.3:1, 1.5:1, 1.7:1, 2.0:1,
2.5:1, 3.0:1, 3.5:1, 4.0:1, 5.0:1, 6.0:1,
8.0:1, 10:1, 20:1, (15 points)
This determines the amount of compression.
ATTACK (ms)
0–120 (121 points)
This determines how soon the signal is compressed or expanded once the com-
pander has been triggered.
RELEASE (ms)
44.1kHz: 6 ms – 46.0 sec
48kHz: 5 ms – 42.3 sec
88.2kHz: 3 ms – 23.0 sec
96kHz: 3 ms – 21.1 sec (160 points)
This determines how soon the compressor or expander returns to the normal gain
once the trigger signal level drops below or exceeds the threshold respectively. The
value is expressed as the duration required for the level to change by 6 dB.
OUT GAIN (dB)
–18.0 to 0.0 (181 points)
This sets the compander’s output signal level.
WIDTH (dB)
1–90 (90 points)
This determines how far below the threshold expansion will be applied. The expander
is activated when the level drops below the threshold and width.
0dB
Input Level
Output Level
THRESHOLD
WIDTH