GE Industrial Solutions AF-300 MICRO-$AVER II - Manual (Page 24)

4-5
Figure 4-5.
DYNAMIC BRAKING RESISTOR CONNECTIONS
* Not available on 6KM$221F25X1A1, 6KM$221F25A4A1, 6KM$223F25X1A1, 6KM$223F25A4A1.
* Factory installed jumper
CONTROL CIRCUIT TERMINAL BLOCK LAYOUT
#1 CAUTION:
Remove jumper from between terminals THR and CM when
a motor overload or a motor temperature switch is used.
Wire the device thermal switch in series with the THR and
CM terminals.
#2 NOTE:
FWD to CM jumper required for operation using keypad
RUN-STOP.
Figure 4-4.
30A 30B Y1 FMA PLC BX RST C1 13 12 11
30C FMP X1 X2 X3 X4 REV FWD THR CM
* * #1 #2
L1 L2 L3 P1 P(+) DB* U V W
E(G)
DB
RESISTOR