GE Industrial Solutions AF-300 MICRO-$AVER II User Manual
Page 56
LED
Data
Factory
Customer
Display
Setting
Description
Setting
Setting
6-17
F_43
X4 TERMINAL FUNCTION
0
The function for the X4 input terminal can be selected from
the following four options.
0:
Functions as a command input terminal X4 for
switching to acceleration/deceleration time 2.
The acceleration time 2 and deceleration time 2 are set
by F_63 and F_64.
1:
Enables the use of multistep frequency settings 8 to 15.
Frequencies 8 to 15 are set by means of F_44 to F_51.
2:
Functions as a command terminal X4 for switching
to base frequency 2 when using a second motor, etc.
When base frequency 2 is selected, acceleration/
deceleration time 2, torque boost 2 and electronic
overload 2 are selected simultaneously.
Base frequency 2 is set using function F_62, acceleration/
deceleration time 2 are set by function F_63 and F_64,
torque boost 2 is set by function F_65, and electronic
overload 2 is set by F_66 and F_67.
3:
Functions as a hold signal (HLD) for operation commands
during 3-wire control operation.
*F_44
MULTISTEP FREQUENCY SETTING 8
0.00
*F_45
MULTISTEP FREQUENCY SETTING 9
0.00
*F_46
MULTISTEP FREQUENCY SETTING 10
0.00
*F_47
0 to 400
MULTISTEP FREQUENCY SETTING 11
0.00
*F_48
MULTISTEP FREQUENCY SETTING 12
0.00
*F_49
MULTISTEP FREQUENCY SETTING 13
0.00
*F_50
MULTISTEP FREQUENCY SETTING 14
0.00
*F_51
MULTISTEP FREQUENCY SETTING 15
0.00
These set the 8 multistep frequencies from frequency 8 to
frequency 15 within the range of 0 to 400Hz.
The setting step is the same as for functions F_21 through
F_27.
(Relationship between terminals and multistep frequencies
8 through 15)
•
= ON/CLOSED.
NOTE: These functions are only active when F_43 = 1 (X4).
Function
44
45
46
47
48
49
50
51
Multistep
Speed Speed Speed Speed Speed Speed Speed Speed
Frequency
8
9
10
11
12
13
14
15
X1 – CM
•
•
•
•
X2 – CM
•
•
•
•
X3 – CM
•
•
•
•
X4 – CM
•
•
•
•
•
•
•
•