GE Industrial Solutions AF-300 MICRO-$AVER II - Manual (Page 80)

9-1
WARRANTY PARTS AND SERVICE
The purpose of the following section is to provide
specific instructions to the user of the AF-300 Micro-
$aver II Drive regarding warranty administration and
how to obtain assistance on both in-warranty and out-
of-warranty equipment.
For all troubleshooting procedures, refer to Section 8
of this Instruction Book. To identify the part or assem-
bly use the noted troubleshooting procedures in Sec-
tion 8 and the information on page 9-2.
If assistance is required to either determine warranty
status or identify defective parts call:
GE Fuji Drives USA, Inc.
1501 Roanoke Blvd. Suite 435
Salem, VA 24153
1-540-387-5739
WARRANTY COVERAGE
The Warranty set forth in Section 1 of FN-1090 (1/91)
of GE's Condition of Sale covers all major parts of the
Drive such as the main printed circuit boards, transis-
tor modules, etc. The warranty covers replacement of
the entire Drive.
"Warranty period is 12 months after installation or 18
months after shipment from the Company, whichever
occurs first."
Before calling the number at left to determine warranty
status, the Drive serial number will be required. This
is located on the Drive nameplate. If the Drive is still
under warranty, further information will be required
per the "In-Warranty Failure Checklist" shown on
page 9-2 of this Instruction Book.
OUT-OF-WARRANTY PROCEDURES
When the defective part has been identified, contact
your local Authorized AF-300 Micro-$aver II Distribu-
tor to order replacement parts.
MOTORS
Repairs on motors are generally handled by the motor
manufacturer. For specific instructions on your motor,
call the distributor from which it was purchased and be
prepared to furnish complete nameplate data.
Section
9