Brocade Network OS Command Reference v4.1.0 - Manual (Page 229)

Network OS Command Reference 191
53-1003115-01
debug lacp
2
port Specifies a valid port number.
interface gigabitethernet rbridge-id/slot/port
Specifies a valid 1-gigabit Ethernet interface.
rbridge-id Specifies the routing bridge ID. This is not valid in standalone mode.
slot Specifies a valid slot number.
port Specifies a valid port number.
sync Echo synchronization to consoles.
timer Echo timer expiration to console.
trace level number Specifies the trace level number. Valid values range from 1 through 7.
Defaults LACP debugging is disabled.
Command Modes Privileged EXEC mode
Description Use this command to enable or disable debugging for Link Aggregation Control Protocol (LACP).
Usage Guidelines Enter terminal monitor to display debugging outputs on a particular cmsh session.
Enter no debug lacp to disable LACP debugging.
Examples To enable debugging of LACP PDUs for transmitted and received packets on all interfaces:
switch# debug lacp pdu tx all
switch# debug lacp pdu rx all
switch# show debug lacp
LACP rx debugging is on
LACP tx debugging is on
See Also show debug lacp