Brocade Network OS Command Reference v4.1.0 - Manual (Page 603)

Network OS Command Reference 565
53-1003115-01
protocol edge-loop-detection
2
protocol edge-loop-detection
Sets the edge-loop detection (ELD) configuration mode.
Synopsis protocol edge-loop-detection
Operands None
Defaults ELD configuration mode is not set.
Command Modes Global configuration mode
Description Use this command to enter the ELD configuration mode to make changes to the ELD configuration.
Usage Guidelines This functionality detects Layer 2 loops only.
Examples To enter the ELD configuration mode:
switch(config)# protocol edge-loop-detection
switch(config-eld)#
See Also hello-interval, pdu-rx-limit, shutdown-time