Brocade Network OS Command Reference v4.1.0 - Manual (Page 42)

4 Network OS Command Reference
53-1003115-01
Network OS CLI command modes
1
Protocol
configuration LLDP:
switch(conf-lldp)#
Spanning-tree:
switch(config-mstp)#
switch(config-rstp)#
switch(config-stp)#
switch(config-pvst)#
switch(config-rpvst)#
switch(conf-udld)#
From global configuration mode, specify
a protocol by entering one of the
following commands:
•
protocol lldp
•
protocol spanning-tree mstp
•
protocol spanning-tree rstp
•
protocol spanning-tree stp
•
protocol spanning-tree pvst
•
protocol spanning-tree rapid-pvst
•
protocol udld
Access and configure
protocols.
FCoE
configuration FCoE:
switch(config-fcoe)#
FCoE fabric-map sub-mode:
switch(config-fcoe-fabric-map)#
FCoE map sub-mode:
switch(config-fcoe-map)#
From global configuration mode, use the
fcoe command to enter FCoE
configuration mode.
From FCoE configuration mode, specify
an FCoE sub-mode by entering one of
the following commands:
•
fabric-map default
•
map default
Access and configure
FCoE features.
Access
Gateway (AG)
configuration AG configuration mode:
switch(config-rbridge-12-ag)#
N_Port configuration mode:
switch(config-rbridge-12-ag-nport-if-
fi-port)#
Port Grouping configuration mode.
switch(config-rbridge-12-ag-pg-pgid)#
From RBridge-ID configuration mode,
enter the ag command.
From AG configuration mode, enter the
nport port command where port is an
N_Port number supported by the
hardware platform.
From AG configuration mode, enter pg
pgid where pgid is the port group
identification number.
Access and configure
Access Gateway
features.
AMPP
port-profile
mode AMPP port-profile:
switch(config-port-profile-name)#
VLAN-profile sub-mode:
switch(config-vlan-profile)#
QoS-profile sub-mode:
switch(config-qos-profile)#
FCoE-profile sub-mode:
switch(config-fcoe-profile)#
Security-profile sub-mode:
switch(config-security-profile)#
From the global configuration mode,
enter the port-profile command to enter
port-profile configuration mode.
From port-profile configuration mode,
specify an AMPP sub-mode by entering
one of the following commands:
•
vlan-profile
•
qos-profile
•
fcoe-profile
•
security-profile
Access and configure
AMPP features.
Network OS CLI command modes (Continued)
Command mode Prompt How to access the command mode Description