Brocade Network OS Command Reference v4.1.0 User Manual
Page 345
Network OS Command Reference
307
53-1003115-01
firmware install
2
Usage Guidelines
•
In a dual-MM system, after firmware install is completed on both MMs, reboot them at the
same time. Otherwise, the MMs may run into configuration mismatch issue.
•
If vcs-id or rbridge-id are specified, vcs-mode cannot be set to 2 (standalone).
•
On the Brocade 8770, 6740, 6740T, and 6740T-1G, vcs-mode cannot be set to 2
(standalone).
•
If you want to change vcs-mode from standalone to either fabric cluster mode or logical
chassis cluster mode, you must use both the vcs-id and rbridge-id options with this command.
•
If you specify at least one of the vcs-mode, vcs-id or rbridge-id parameters, then the remaining
parameters will get their values from the existing configuration — unless you also specify their
values in the command line.
Examples
To install new firmware, delete all existing configurations, and to specifiy the vcs mode, vcs ID and
RBridge ID you want the switch to come up in:
switch# firmware install scp host 10.70.4.109 user fvt pass pray4green directory
/buildsjc/sre/SQA/nos/nos4.1.0/nos4.1.0_bld25 vcs-mode 1 vcs-id 6 rbridgeid 10
See Also
None