Brocade Network OS Command Reference v4.1.0 - Manual (Page 957)

Network OS Command Reference 919
53-1003115-01
show mac-address-table
2
port Specifies a valid port number.
gigabitethernet rbridge-id/slot/port
Specifies a valid 1-gigabit Ethernet line-card interface.
rbridge-id Specifies the RBridge ID.
slot Specifies a valid slot number.
port Specifies a valid port number.
static Displays the static MAC addresses.
vlan vlan_id Specifies the VLAN number. Refer to the Usage Guidelines.
port-profile Displays MAC addresses associated with port profiles.
address mac-address
Specifies a 48-bit MAC address. The valid format is H.H.H.
count Displays the count of forwarding entries associated with port profiles.
dynamic Displays dynamic MAC addresses associated with port profiles.
static Displays static MAC addresses associated with port profiles.
vlan vlan_id Displays MAC addresses associated with port profiles and the specified
VLAN. Refer to Usage Guidelines below.
Defaults No static addresses are configured.
Command Modes Privileged EXEC mode
Description Use this command to display a specific static or dynamic MAC address entry or all entries for a
specific interface, a specific VLAN, a specific linecard, or for all interfaces and all VLANs.
Usage Guidelines The gigabitethernet rbridge-id/slot/port parameter is used only on Brocade VDX 6710,
Brocade VDX 8770-4, and Brocade VDX 8770-8 switches.
On the Brocade VDX family of switches, VLANs are treated as interfaces from a configuration point
of view. By default, all the DCB ports are assigned to VLAN 1 (VLAN ID equals 1). Valid VLAN IDs
are as follows:
• On Brocade VDX 8770 switches: 1 through 4086 for 802.1Q VLANs (VLAN IDs 4087
through 4095 are reserved on these switches), and 4096 through 8191 for service or
transport VFs in a Virtual Fabrics context.
• On all other Brocade VDX switches: 1 through 3962 for 802.1Q VLANs (VLAN IDs 3963
through 4095 are reserved on these switches), and 4096 through 8191 for service or
transport VFs in a Virtual Fabrics context.
Examples To display a specific MAC address in the table:
switch# show mac-address-table address 0011.2222.3333
vlanId Mac-address Type State Ports
100 0011.2222.3333 Static Inactive Te 0/1
Total MAC addresses : 1
To display the aging time for a specific MAC address table:
switch# show mac-address-table aging-time
MAC Aging-time : 300 seconds