Allied Telesis AT-S63 - Manual (Page 113)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Operations 113
The Port Configuration menu is shown in Figure 26.
Figure 26. Port Configuration (Port) Menu
Note
If you are configuring multiple ports and the ports have different
settings, the Port Configuration menu displays the settings of the
lowest numbered port.
4. Adjust the following parameters as necessary.
Note
A change to a parameter is immediately activated on the port.
0 - Description
You use this option to assign a description to a port, from 1 to 15
alphanumeric characters. Spaces are allowed, but you should not use
special characters, such as asterisks or exclamation points. (You
cannot set a port description if you are configuring more than one port.)
1 - Status
You use this option to enable or disable a port. When disabled, a port
does not forward frames to or from the node connected to the port.
You might want to disable a port and prevent packets from being
forwarded if a problem occurs with the node or cable connected to the
port. After the problem has been fixed, you can enable the port again
to resume normal operation.
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Port Configuration
Configuring Port 11
0 - Description ........................ Port_11
1 - Status ............................. Enabled
2 - HOL Blocking Prevention Threshold .. 682 cells
3 - Flow Control
4 - Filtering
5 - Rate Limiting
6 - Negotiation ........................ Auto
X - Reset Port
F - Force Renegotiation
D - Set Port Configuration to Defaults
R - Return to Previous Menu
Enter your selection?