Allied Telesis AT-S63 - Manual (Page 31)

AT-S63 Management Software Menus Interface User’s Guide
31
Version 1.2.0 Table 2 lists the new features in version 1.2.0.
Table 2. New Features in AT-S63 Version 1.2.0
Change Chapter and Procedure
MAC Address Table
Added new parameters to the CLI
commands for displaying and deleting
specific types of MAC addresses in the
MAC address table. The new
parameters are:
ˆ STATIC, STATICUNICAST, and,
STATICMULTICAST for displaying
and deleting static unicast and
multicast MAC addresses.
ˆ DYNAMIC, DYNAMICUNICAST,
and, DYNAMICMULTICAST for
displaying and deleting dynamic
unicast and multicast MAC
addresses.
The menus interface supports displaying MAC
addresses, as explained in Chapter 7, “MAC Address
Table” on page 135, but not the new parameters. The
new parameters are only supported in the CLI
interface.
Quality of Service - Flow Groups and Traffic Classes
Added the following new parameters to
QoS flow groups and traffic classes:
ˆ ToS parameter for replacing the
Type of Service field of IPv4
packets.
ˆ Move ToS to Priority parameter for
replacing the value in the 802.1p
priority field with the value in the
ToS priority field in IPv4 packets.
ˆ Move Priority to ToS parameter for
replacing the value in the ToS
priority field with the 802.1p priority
field in IPv4 packets.
Chapter 17, “Quality of Service” on page 335
Modified procedures:
ˆ “Creating a Flow Group” on page 351
ˆ “Modifying a Flow Group” on page 354
ˆ “Creating a Traffic Class” on page 360
ˆ “Modifying a Traffic Class” on page 364