Allied Telesis AT-S63 - Manual (Page 675)

AT-S63 Management Software Menus Interface User’s Guide
Section VI: VLANs 675
12. Type C to select Create VLAN.
The following prompt is displayed:
Enter Uplink Ports (4 - 12) ->
The prompt will shown the ports that you specified as belonging to the
VLAN.
13. Enter the port in the VLAN that will function as the uplink port for the
different VLAN groups. You can select more than one uplink port.
The following prompt is displayed:
Enter Group Ports (4 - 11) ->
The prompt lists the ports in the VLAN, minus the uplink port you
specified in the previous step.
14. Specify the ports of one of the groups of the protected ports VLAN.
This can be a few as one port or as many as all the remaining ports of
the VLAN. You can specify the ports of the group individually (e.g.,
2,3,5), as a range (e.g., 7-9), or both (e.g., 2,5,7-9).
The following prompt is displayed:
Enter Group Number ->
15. Enter a group number for the port(s). Each group on the switch must
be have a unique group number. The range is 1 to 256.
16. If there are ports within the VLAN that still need to be assigned to a
group, the prompt in Step 13 is displayed again, showing the
unassigned ports. You must repeat Steps 14 and 15, creating
additional groups, until all of the ports in the VLAN have been assigned
to a group.
After you create all of the groups, the following prompt is displayed:
SUCCESS - Press any key to continue.
Press any key to continue.
The new protected ports VLAN and its groups are now active on the
switch.
17. Press any key to return to the Configure VLANs menu.
18. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.