Allied Telesis AT-S63 - Manual (Page 293)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 293
Modifying a Classifier
In order to modify a classifier, you need to know its ID number. If you are
unsure of the ID number of the classifier you want to modify, refer to
“Displaying Classifiers” on page 297.
You cannot modify a classifier if it belongs to an ACL or QoS policy that
has already been assigned to a port. You must first remove the port
assignments from the ACL or policy before you can modify the classifier.
To modify a classifier, perform the following procedure:
1. From the Main Menu, type 7 to select Security and Services.
The Security and Services menu is shown in Figure 86 on page 289.
2. From the Security and Services menu, type 1 to select Classifier
Configuration.
The Classifier Configuration menu is shown in Figure 87 on page 290.
3. From the Classifier Configuration menu, type 2 to select Modify
Classifier.
The prompt similar to the following is displayed:
Available Classifier(s): 1-12
Enter Classifier ID : [1 to 9999] -> 1
4. Enter the ID number of the classifier you want to modify.
The Modify Classifier window is displayed. This window is identical to
the Create Classifier menus, shown in Figure 88 on page 290 and
Figure 89 on page 291.
5. Edit the variables as needed.
When modifying a classifier, note the following:
ˆ You cannot change a classifier’s ID number.
ˆ To delete a value from a variable so as to leave it blank, select the
criterion and then use the backspace key to delete its default value.
6. Once you have adjusted the variables, type M to select Modify
Classifier.
A change to a classifier is immediately activated. If any of the settings
are incompatible, the system displays an error message. Refer to the
variable definitions in “Classifier Criteria” on page 283 for assistance in
resolving any compatibility issues.