Allied Telesis AT-S63 - Manual (Page 295)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 295
Deleting a Classifier
This procedure deletes a classifier from the switch. To delete a classifier,
you need to know its ID number. If you are unsure of the ID number of the
classifier you want to delete, refer to “Displaying Classifiers” on page 297.
Note
You cannot delete a classifier if it belongs to an ACL or QoS
policy.You must first remove the classifier from its ACL or policy
assignments before you can delete it.
To delete a classifier, perform the following procedure:
1. From the Main Menu, type 7 to select Security and Services.
The Security and Services menu is shown in Figure 86 on page 289.
2. From the Security and Services menu, type 1 to select Classifier
Configuration.
The Classifier Configuration menu is shown in Figure 87 on page 290.
3. From the Classifier Configuration menu, type 3 to select Destroy
Classifier.
The following prompt is displayed:
Enter Classifier ID : [1 to 9999] -> 1
4. Enter the ID number of the classifier you want to delete.
The details of the specified classifier are displayed. Use this window to
verify that you are deleting the correct classifier.
5. If this is the correct classifier, type D to select Destroy Classifier.
The classifier is deleted from the switch.
6. To delete additional classifiers, repeat this procedure starting with step
3.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.