Allied Telesis AT-S63 - Manual (Page 744)

Chapter 31: 802.1x Port-based Network Access Control
744 Section VII: Port Security
Note
This parameter is only available when the authenticator’s mode is
set to Single. For further information, refer to “Authenticator Ports
with Single and Multiple Supplicants” on page 723.
E - Guest VLAN
This parameter specifies the name or VID of a Guest VLAN. The
authenticator port is a member of a Guest VLAN when no supplicant is
logged on. Clients do not log on to access a Guest VLAN. To remove a
Guest VLAN without assigning a new one, enter “none”.
For further information, refer to “Guest VLAN” on page 731.
7. Repeat this procedure starting with Step 4 to configure additional
authenticator ports on the switch.
8. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.