Allied Telesis AT-S63 - Manual (Page 615)

AT-S63 Management Software Menus Interface User’s Guide
Section VI: VLANs 615
Example of Creating a Port-based VLAN
The following procedure creates the Sales VLAN illustrated in “Port-based
Example 1” on page 603. This VLAN will be assigned a VID of 2 and will
consist of four untagged ports, ports 1, 3 to 5. The VLAN will not contain
any tagged ports.
To create the Sales VLAN, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 206 on page 610.
2. From the VLAN Configuration menu, type 4 to select Configure
VLANs.
The Configure VLANs menu is shown in Figure 207 on page 611.
3. From the Configure VLANs menu, type 1 to select Create VLAN.
The Create VLAN menu is shown in Figure 208 on page 611.
4. From the Create VLAN menu, type 1 to select VLAN Name and enter
“Sales”.
5. Type 2 to select VLAN ID (VID) and enter “2”. This is the VID value for
the new VLAN.
6. Type 3 to toggle VLAN Type to Port Based.
Note
Option 4, Tagged Ports, is left empty because this VLAN will not
contain any tagged ports.
7. Type 5 to select Untagged Ports and enter “1,3-5”. These are the
untagged ports of the VLAN. Press Return.
Note
Option 6, Protected Ports, must be left in the “No” default setting
when creating a port-based or tagged VLAN. This option is
explained in Chapter 28, “Protected Ports VLANs” on page 669.
8. Type C to select Create VLAN.
9. After the switch displays the prompt notifying you that it created the
VLAN, press any key.
The new Sales VLAN has now been created.