Allied Telesis AT-S63 - Manual (Page 537)

AT-S63 Management Software Menus Interface User’s Guide
Section V: Spanning Tree Protocols 537
Configuring STP
This section contains the following procedures:
ˆ ”Configuring STP Bridge Settings”, next
ˆ “Configuring STP Port Settings” on page 539
Configuring STP
Bridge Settings
This section contains the procedure for configuring a bridge’s STP
settings.
Caution
The default STP parameters are adequate for most networks.
Changing them without prior experience and an understanding of
how STP works might have a negative effect on your network. You
should consult the IEEE 802.1d standard before changing any of the
STP parameters.
To configure the bridge settings, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 177 on
page 535.
2. From the Spanning Tree Configuration menu, type 3 to select
Configure Active Protocol. The STP menu is shown in Figure 178.
Figure 178. STP Menu
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
STP Menu
1 - Bridge Priority ..... 32768
2 - Bridge Hello Time ... 2/2 (Configured/Actual)
3 - Bridge Forwarding ... 15/15 (Configured/Actual)
4 - Bridge Max Age ...... 20/20 (Configured/Actual)
5 - Bridge Identifier ... 32768/00:21:46:A7:B4:11
6 - Root Bridge ......... 00:21:46:A7:B4:11
7 - Root Priority ....... 32768
8 - Root Path Cost ...... 0
P - STP Port Settings
D - Reset STP to Defaults
R - Return to Previous Menu
Enter your selection?