Allied Telesis AT-S63 - Manual (Page 581)

AT-S63 Management Software Menus Interface User’s Guide
Section V: Spanning Tree Protocols 581
The following prompt is displayed:
Enter the MSTI ID <enter 0 for CIST> [0 to 15] ->
6. Enter the MSTI ID to which you want to associate a VLAN.
A prompt similar to the following is displayed:
Enter the list of VLANs:
7. Enter the VLAN ID of the virtual LAN that you want to remove from the
MSTI ID. You can enter more than one VLAN at a time (for example,
2,4,7) To view VIDs, refer to “Displaying VLANs” on page 621.
A removed VLAN is returned to CIST.
8. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Associating
VLANs to an
MSTI ID and
Deleting All
Associated
VLANs
To associate VLANs to an MSTP ID while deleting all VLANs that are
already associated with it, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 177 on
page 535.
2. From the Spanning Tree Configuration menu, type 3 to select
Configure Active Protocol.
The MSTP menu is shown in Figure 194 on page 568.
3. From the MSTP menu, type M to select MSTI menu.
The MSTI menu is shown in Figure 196 on page 573
4. From the MSTP menu, type V to select VLAN-MSTI Association menu.
The VLAN-MSTI Association menu is shown in Figure 197 on page
579.
5. From the VLAN-MSTI Association menu, type 1 to select Add VLANs
to MSTI.
The following prompt is displayed:
Enter the MSTI ID <enter 0 for CIST> [0 to 15] ->
6. Enter the MSTI ID to which you want to associate a VLAN.
7. A prompt similar to the following is displayed:
Enter the list of VLANs: