Forcing port renegotiation – Allied Telesis AT-S63 User Manual
Page 126
Chapter 6: Port Parameters
126
Section I: Basic Operations
Forcing Port Renegotiation
Port renegotiation prompts a port operating in Auto-Negotiation to
renegotiate its speed and duplex mode with its end node. This option is
useful if you believe that a port and end node are not operating at the
same speed and duplex mode.
To force port renegotiation, perform the following procedure:
1. From the Main Menu, type 1 to select Port Configuration.
The Port Configuration menu is shown in Figure 25 on page 112.
2. From the Port Configuration menu, type 1 to select Port Configuration.
The following prompt is displayed:
Enter port-list ->
3. Enter the number of the port you want to reset. To reset a range of
ports, enter the first and last ports of the range, separated by a dash
(for example, 4-8). You cannot specify nonconsecutive ports (for
example, 5,7,9)
The Port Configuration menu is shown in Figure 26 on page 113.
4. From the Port Configuration menu, type F to select Force
Renegotiation.