Allied Telesis AT-S63 - Manual (Page 841)

AT-S63 Management Software Menus Interface User’s Guide
Section VIII: Management Security 841
Manager and Operator accounts. The default is 10 seconds. The
range is 1 to 60 seconds.
3 - RADIUS Server 1 Configuration
4 - RADIUS Server 1 Configuration
5 - RADIUS Server 1 Configuration
Use these parameters to specify the IP addresses of up to three
network servers containing the RADIUS server software. Selecting one
of the options displays the RADIUS Server Configuration menu, shown
in Figure 286.
Figure 286. RADIUS Server Configuration
Adjust the following parameters as necessary:
1 - Server IP Address
Use this option to specify the IP address of the RADIUS server.
2 - Server Authentication UDP Port
Use this option to specify the UDP port of the RADIUS protocol.
3 - Server Encryption Key
Use this option to specify the encryption key for the RADIUS server.
If you are using the RADIUS client software to support 802.1x port-
based network access control, but not new manager accounts, no
further steps are required after you configure the parameters in the
RADIUS Server Configuration menu. You can return to the main menu
and type S to select Save Configuration Changes.
However, if you are using the RADIUS client software to support new
manager accounts, you must perform steps 5 to 7 to activate the
feature.
5. After you finish configuring the parameters in the RADIUS Client
Configuration menu, type R to return to the Authentication
Configuration menu, shown in Figure 282 on page 834.
6. To activate the feature, perform the procedure “Enabling Server-based
Management Authentication” on page 834.
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
RADIUS Server 1 Configuration
1 - Server IP Address ................. 0.0.0.0
2 - Server Authentication UDP Port .... 1812
3 - Server Encryption Key ............. <Not Defined>
R - Return to Previous Menu
Enter your selection?