Allied Telesis AT-S63 - Manual (Page 278)

Chapter 13: Event Logs and Syslog Servers
278 Section II: Advanced Operations
15. Enter a list of modules separated by a comma—for example, “system,
stp, ptrunk.”
16. Type C to create the log output you defined.
The switch immediately adds the new syslog server definition to the
Configure Log Outputs menu and begins to send events to the sever, if
you enabled the definition when you created it. An example of the
menu with a new syslog server definition is shown in Figure 82.
Figure 82. Configure Log Outputs Menu with a Syslog Output Definition
17. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying a Log
Output
To modify a log output definition you have already created, perform the
following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 54.
2. From the System Administration menu, type 8 to select Event Log.
The Event Log menu is shown in Figure 76 on page 261.
3. From the Event Log menu, type L to select Configure Log Outputs.
The Configure Log Outputs menu is shown in Figure 80 on page 273.
4. From the Configure Log Outputs menu, type 2 to select Modify Log
Output.
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Configure Log Outputs
OutputID Type Status Details
------------------------------------------------------
0
Permanent Enabled Wrap on Full
1 Temporary Enabled Wrap on Full
2 Syslog Enabled 149.44.44.44
1 - Create Log Output
2 - Modify Log Output
3 - Delete Log Output
4 - View Log Output Details
R - Return to Previous Menu
Enter your selection?