Allied Telesis AT-S63 - Manual (Page 677)

AT-S63 Management Software Menus Interface User’s Guide
Section VI: VLANs 677
The Modify VLAN menu is shown in Figure 209 on page 617.
4. Type 1 to select VLAN ID (VID).
The following prompt is displayed:
Enter new value -> [1 to 4096] ->
5. Enter the VID of the VLAN you want to modify.
The Modify VLAN menu expands to contain all relevant information
about the VLAN, as shown in Figure 232.
Figure 232. Expanded Modify VLAN Menu
6. Adjust the following parameters as necessary.
1 - VLAN Name
Use this selection to change the name of a VLAN. The name can be
from one to fifteen alphanumeric characters in length. The name
cannot contain spaces or special characters, such as asterisks (*) or
exclamation points (!).
When you change a VLAN’s name, observe the following guidelines:
ˆ A VLAN’s new name cannot be the same as the name of another
VLAN on the same switch.
ˆ You cannot change the name of the Default_VLAN.
Note
A VLAN must have a name.
2 - VLAN ID (VID)
This is the VLAN’s VID value. You cannot change this value.
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Modify VLAN
1 - VLAN Name .............. Internet_1
2 - VLAN ID (VID) .......... 3
3 - Tagged Ports ........... 7,9
4 - Untagged Ports ......... 20-24
5 - Protected Ports ........ Yes
M - Modify VLAN
R - Return to Previous Menu
Enter your selection?