Allied Telesis AT-S63 - Manual (Page 696)

Chapter 29: MAC Address-based VLANs
696 Section VI: Virtual LANs
Adding and Deleting MAC Addresses
This procedure explains how to add and delete MAC addresses from a
MAC address-based VLAN. If you are creating a new VLAN, you perform
this procedure after you initially create the VLAN by giving it a name and a
VID and setting the VLAN type, as explained in “Creating a MAC Address-
based VLAN” on page 693. After you assign the MAC addresses to the
VLAN, you must specify the egress ports, as described in “Adding and
Deleting Egress Ports” on page 698.
You cannot remove a MAC address from a VLAN if the address has been
assigned egress ports. You must first remove the ports from the MAC
address before you can delete it. For instructions, refer to “Adding and
Deleting Egress Ports” on page 698.
To add or delete MAC addresses from a MAC address-based VLAN,
perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 206 on page 610.
2. From the VLAN Configuration menu, type 4 to select Configure
VLANs.
The Configure VLANs menu is shown in Figure 207 on page 611.
3. From the Configure VLANs menu, type 2 to select Modify VLAN.
The Modify VLAN menu is shown in Figure 209 on page 617.
4. From the Modify VLAN menu, type 3 to select Configure MAC
Associations.
The MAC Based VLANs menu is shown in Figure 238.
Figure 238. MAC Based VLANs Menu
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
MAC Based VLANs
1 - Add MAC Address
2 - Delete MAC Address
3 - Add Ports
4 - Delete Ports
R - Return to Previous Menu
Enter your selection?