Allied Telesis AT-S63 - Manual (Page 699)

AT-S63 Management Software Menus Interface User’s Guide
Section VI: Virtual LANs 699
6. Enter the VID of the MAC address-based VLAN where you want to add
or delete an egress port. You can enter only one VID. To display the
VIDs, refer to “Displaying MAC Address-based VLANs” on page 702.
The following prompt is displayed:
Please enter MAC address ->
7. Enter the MAC address where you want to add or delete an egress
port. You can specify only one address and the address must already
exist in the VLAN. For instructions on how to add an address to a
VLAN, refer to “Adding and Deleting MAC Addresses” on page 696.
You can enter the address in either of the following formats:
xx:xx:xx:xx:xx:xx or xxxxxxxxxxxx
The following prompt is displayed:
Please enter port number(s):
8. Enter the egress port for the address. You can specify more than one
port. You can specify the ports individually (e.g., 2,4,15), as a range
(e.g., 11-15), or both (e.g., 2,4,11-17).
If you are adding an egress port, the port is immediately added to the
MAC address. If you are deleting an egress port, the port is deleted
from the address.
9. To add or delete more egress ports, repeat this procedure starting with
step 5.
10. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.