Allied Telesis AT-S63 - Manual (Page 468)

Chapter 22: SNMPv3
468 Section IV: SNMPv3
3-v3
Select this value to associate the Group Name with the SNMPv3
protocol.
The following prompt is displayed:
Do you want to delete this table entry? (Y/N):[Yes/No]->
6. Enter Y to delete this SecurityToGroup entry or N to save the entry.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying an
SNMPv3
SecurityToGroup
Table Entr y
This section describes how to modify parameters in an SNMPv3
SecurityToGroup Table entry. See the following procedures:
ˆ “Modifying the Group Name” on page 468
ˆ “Modifying the Storage Type” on page 470
Modifying the Group Name
To modify the Group Name in an SNMPv3 SecurityToGroup Table entry,
perform the following procedure.
1. Follow steps 1 through 5 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 430. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table menu is shown in Figure 147 on page
431.
2. From the Configure SNMPv3 Table menu, type 5 to select Configure
SNMPv3 SecurityToGroup Table.
The Configure SNMPv3 SecurityToGroup Table is shown in Figure
152.
3. From the Configure SNMPv3 SecurityToGroup Table, type 3 to select
Modify SNMPv3 Table Entry.