Allied Telesis AT-S63 - Manual (Page 444)

Chapter 22: SNMPv3
444 Section IV: SNMPv3
6. Enter Y to delete the view or N to save the view.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying an
SNMPv3 View
Table Entry
This section describes how to modify parameters in an SNMPv3 Notify
Table entry. See the following procedures:
ˆ “Modifying a Subtree Mask” on page 444
ˆ “Modifying a View Type” on page 446
ˆ “Modifying a Storage Type” on page 447
Modifying a Subtree Mask
To modify the Subtree Mask parameter in an SNMPv3 View Table entry,
perform the following procedure.
1. Follow steps 1 through 5 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 430. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table menu is shown in Figure 147 on page
431.
2. From the Configure SNMPv3 Table menu, type 3 to select Configure
SNMPv3 View Table.
The Configure SNMPv3 View Table menu is shown in Figure 150 on
page 441.
3. From the Configure SNMPv3 View Table menu, type 3 to select Modify
SNMPv3 Table Entry.