Allied Telesis AT-S63 - Manual (Page 274)

Chapter 13: Event Logs and Syslog Servers
274 Section II: Advanced Operations
The Syslog Output Configuration menu is displayed, as shown in
Figure 81.
Figure 81. Syslog Output Configuration Menu
6. From the Syslog Output Configuration menu, type 1 to select Output
ID.
The following prompt is displayed:
Enter new output ID [2 to 20] ->2
7. Type a number between 2 and 20 and press Enter. The output
definition is identified in the Configure Log Outputs menu by this
number. The default is the next available number. You cannot use a
number that is already assigned.
8. Type 2 to select Server IP Address.
The following prompt is displayed:
Enter server IP address:
9. Type the IP address of the syslog server.
10. Type 3 to toggle Message Generation between the following options:
Enabled
Enables the syslog output definition. When enabled, the switch sends
events to the specified syslog server.
Disabled
Disables the syslog output definition. When disabled, which is the
default, the switch does not send events to the syslog server.
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Syslog Output Configuration
1 - Output ID ................ <not defined>
2 - Server IP Address ........ 0.0.0.0
3 - Message Generation ....... Disabled
4 - Message Format ........... Extended
5 - Facility Level ........... DEFAULT
6 - Event Severity ........... E,W,I
7 - Event Module ............. All
C - Create Log Output
R - Return to Previous Menu
Enter your selection?