Allied Telesis AT-S63 - Manual (Page 163)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Features 163
ˆ If you are adding a port and the port will not be the lowest numbered
port in the trunk, its settings will be changed to match the settings of
the existing ports in the trunk.
ˆ If you are adding a port to a static trunk, you should check to be sure
that the new port is an untagged member of the same VLAN as the
other trunk ports. A trunk cannot contain ports that are untagged
members of different VLANs.
To modify a port trunk, perform the following procedure:
1. From the Main Menu, type 1 to select Port Configuration.
The Port Configuration menu is shown in Figure 25 on page 112.
2. From the Port Configuration menu, type 4 to select Port Trunking and
LACP.
The Port Trunking and LACP menu is shown in Figure 42 on page 160.
3. From the Port Trunking and LACP menu, type 1 to select Static Port
Trunking.
The Static Port Trunking menu is shown in Figure 43 on page 160.
4. Type M to select Modify Trunk.
The following prompt is displayed:
Enter Trunk ID: [1 to 6] ->
5. Enter the ID number of the trunk you want to modify.
The Modify Trunk menu is displayed. The menu displays the operating
specifications of the selected trunk. An example is shown in Figure 45.
Figure 45. Modify Trunk Menu
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Modify Trunk
1 - Trunk ID ......... 2
2 - Trunk Name ....... Server11
3 - Trunk Method ..... SRC/DST MAC
4 - Trunk Ports ...... 12-16
M - Modify Trunk
R - Return to Previous Menu
Enter your selection?