Allied Telesis AT-S63 - Manual (Page 470)

Chapter 22: SNMPv3
470 Section IV: SNMPv3
3-v3
Select this value to associate the User Name with the SNMPv3
protocol.
The following prompt is displayed:
Enter Group Name:
7. Enter the new Group Name.
This value must match a value configured in the Group Name
parameter in the Configure SNMPv3 Access Table. See “Creating an
SNMPv3 Access Table Entry” on page 449.
8. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying the Storage Type
To modify the Storage Type in an SNMPv3 SecurityToGroup Table entry,
perform the following procedure.
1. Follow steps 1 through 5 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 430. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table menu is shown in Figure 147 on page
431.
2. From the Configure SNMPv3 Table menu, type 5 to select Configure
SNMPv3 SecurityToGroup Table.
The Configure SNMPv3 SecurityToGroup Table is shown in Figure 152
on page 450.
3. From the Configure SNMPv3 SecurityToGroup Table, type 3 to select
Modify SNMPv3 Table Entry.
4. To modify the storage type, type 2 to select Set Storage Type.
The following prompt is displayed:
Enter User (Security) Name:
5. Enter a User Name.
The User Name must be previously configured in the Configure
SNMPv3 User Table menu. See “Creating an SNMPv3 User Table
Entry” on page 430.
The following prompt is displayed:
Enter Security Model [1-v1, 2-v2c, 3-v3]: