Allied Telesis AT-S63 - Manual (Page 175)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Operations 175
The LACP (IEEE 8023ad) Configuration menu is shown in Figure 45.
Figure 45. LACP (IEEE 8023ad) Configuration Menu
4. Type 1 to toggle LACP Status between Disabled and Enabled. The
default is disabled.
5. To permanently save your change, return to the Main Menu and type S
to select Save Configuration Changes.
Setting the LACP
System Priority
This procedure explains how to set the LACP system priority value on a
switch. The switch uses this parameter if a conflict occurs when
establishing an aggregate trunk with the other device. The LACP settings
on the device with the higher priority take precedence over the settings on
the other device. The lower the value, the higher the priority. A switch can
have only one LACP system priority. For more information, refer to “LACP
System Priority” on page 161.
To set the LACP system priority for the switch, perform the following
procedure:
1. From the Main Menu, type 1 to select Port Configuration.
2. From the Port Configuration menu, type 4 to select Port Trunking and
LACP.
The Port Trunking and LACP menu is shown in Figure 41 on page 168.
3. Type 2 to select LACP Configuration.
The LACP (IEEE 8023ad) Configuration menu is shown in Figure 45
on page 175.
4. Type 2 to select Priority.
Allied Telesyn AT-9448T/SP - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
LACP (IEEE 802.3ad) Configuration
1 - LACP Status ................ Disabled
2 - Priority ................... 0x0080
3 - Create Aggregator
4 - Modify Aggregator
5 - Delete Aggregator
6 - Show LACP Port Status
7 - Show LACP Aggregator Status
R - Return to Previous Menu
Enter your selection?