Allied Telesis AT-S63 User Manual
Page 96
Advertising
Chapter 4: Enhanced Stacking
96
Section I: Basic Operations
The menu displays the current status of the switch at the end of
selection “1 - Switch State.” For example, the switch’s current status in
the figure above is master.
Note
Item 2, Stacking Services, is only displayed on master switches.
2. To change a switch’s stacking status, type 1 to select Switch State.
The following prompt is displayed.
Enter new setup (M/S/U) ->
3. Type M to change the switch to a master switch, S to make it a slave
switch, or U to make the switch unavailable. Press Return.
A change to the status is immediately activated on the switch.
4. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Advertising