Allied Telesis AT-S63 - Manual (Page 535)

AT-S63 Management Software Menus Interface User’s Guide
Section V: Spanning Tree Protocols 535
Resetting STP to
the Default
Settings
To reset STP to the default settings, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 170 on
page 527.
2. From the Spanning Tree Configuration menu, type 3 to select
Configure Active Protocol.
The STP menu is shown in Figure 171 on page 530.
3. From the STP menu, type D to select Reset STP to Defaults.
The following prompt is displayed:
Do you want to reset STP configuration to default [Yes/
No] ->
4. Enter Y for Yes or N for No and press Return.
The STP configuration is reset to the defaults.