Allied Telesis AT-S63 - Manual (Page 685)

AT-S63 Management Software Menus Interface User’s Guide
Section VI: Virtual LANs 685
Adding and Deleting MAC Addresses
This procedure explains how to add and delete MAC addresses from a
MAC address-based VLAN. If you are creating a new VLAN, you perform
this procedure after you initially create the VLAN by giving it a name and a
VID and setting the VLAN type, as explained in “Creating a MAC Address-
based VLAN” on page 683. After you assign the MAC addresses to the
VLAN, you must specify the egress ports, as described in “Adding and
Deleting Egress Ports” on page 687.
You cannot remove a MAC address from a VLAN if the address has been
assigned egress ports. You must first remove the ports from the MAC
address before you can delete it. For instructions, refer to “Adding and
Deleting Egress Ports” on page 687.
To add or delete MAC addresses from a MAC address-based VLAN,
perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 199 on page 602.
2. From the VLAN Configuration menu, type 3 to select Configure
VLANs.
The Configure VLANs menu is shown in Figure 200 on page 603.
3. From the Configure VLANs menu, type 2 to select Modify VLAN.
The Modify VLAN menu is shown in Figure 202 on page 609.
4. From the Modify VLAN menu, type 3 to select Configure MAC
Associations.
The MAC Based VLANs menu is shown in Figure 231.
Figure 231. MAC Based VLANs Menu
Allied Telesyn AT-9448T/SP - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
MAC Based VLANs
1 - Add MAC Address
2 - Delete MAC Address
3 - Add Ports
4 - Delete Ports
R - Return to Previous Menu
Enter your selection?