Allied Telesis AT-S63 - Manual (Page 304)

Chapter 14: Access Control Lists
304 Section II: Advanced Operations
The Create ACL menu is shown in Figure 93.
Figure 93. Create ACL Menu
4. Type 1 to select ACL ID and, when prompted, enter an ID number for
the ACL. Every ACL on the switch must have a unique ID number. The
range is 0 to 255. The default is the lowest unused number. This
parameter is required.
5. Type 2 to select Description and enter a description for the ACL. A
description can be up to 31 alphanumeric characters. Spaces are
allowed. This parameter is optional, though recommended. Assigning
the ACLs different names will make it easier for you to identify them.
6. Type 3 to select Action.
The following prompt is displayed:
Enter Value [0 - Deny, 1 - Permit] : [0 to 1] -> 0
7. Type 0 if you want the ACL to discard ingress packets that meet the
criteria in the classifiers to be assigned to the ACL or 1 if the packets
are to be accepted. The default setting is Deny.
8. Type 4 to select Classifier List from the Create ACL menu and, when
prompted, enter the classifiers to be assigned to the ACL. The prompt
includes the ID numbers of the classifiers on the switch. You can
assign more than one classifier to an ACL. Separate multiple
classifiers with a comma (for example, 4,7,2). The order in which you
specify the classifiers is not important.
When entering classifiers, keep in mind the action that you specified
for this ACL in step 7. The action and the traffic flows defined by the
classifiers should correspond. For instance, an ACL with an action of
permit should be assigned those classifiers that define the traffic flow
you want the ports to accept.
Allied Telesyn AT-9424T/SP - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Create ACL
1 - ACL ID ........... 0
2 - Description .......
3 - Action ............ Deny
4 - Classifier List ...
5 - Port List .........
C - Create ACL
R - Return to Previous Menu
Enter your selection?