Allied Telesis AT-S63 - Manual (Page 704)

Chapter 29: Internet Protocol Version 4 Routing Interfaces
704 Section VII: Internet Protocol Routing
Deleting a Routing Interface
This procedure deletes a routing interface from the switch. Note the
following before performing this command:
ˆ All IPv4 packet routing to and from the local network or subnet of a
deleted interface ceases.
ˆ All static routes assigned to the interface are deleted from the routing
table.
ˆ If RIP was assigned to the interface, all dynamic routes learned by the
interface are deleted from the routing table.
ˆ Deleting an interface used by the AT-S63 management software to
communicate with a network device for management purposes (e.g., a
RADIUS or syslog server) causes the switch to stop performing those
management functions.
ˆ Deleting the local interface on a master switch of an enhanced stack
disables the device’s ability to function as the master switch.
ˆ Deleting the local interface of a switch during a remote Telnet or SSH
management session immediately ends the session if you accessed
the switch directly (i.e., not through enhanced stacking). To continue
managing the switch, you must start a local management session
using the Terminal Port on the unit.
To delete a routing interface, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
2. From the System Administration menu, type 2 to select System
Configuration.
3. From the System Configuration menu, type I to select Configure
Interface.
The Configure Interface menu is shown in Figure 236 on page 698.
4. From the Configure Interface menu, type D to select Delete Interface.
The following prompt is displayed:
Enter Interface Name:
5. Enter the name of the interface (e.g., vlan2-1) to be deleted.
The interface is immediately deleted from the switch.
6. To permanently save your change, return to the Main Menu and type S
to select Save Configuration Changes.