Allied Telesis AT-S63 - Manual (Page 67)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Operations 67
Setting the
System Time
Manually
To set the system time manually, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 60.
2. From the System Administration menu, type 2 to select System
Configuration.
The System Configuration menu is shown in Figure 5 on page 61.
3. From the System Configuration menu, type T to select Configure
System Time.
The Configure System Time menu is shown in Figure 8.
Figure 8. Configure System Time Menu
4. From the Configure System Time menu, type 1 to select System Time.
The following prompt is displayed:
Enter new system time [hh:mm:ss] ->
5. Enter a new time for the system in the following format: hours, minutes,
and seconds all separated by colons. The following prompt is
displayed:
Enter new system date [dd-mm-yyyy] ->
6. Enter a new date for the system. Use two numbers to specify the day
and month. Use four numbers to specify the year. Separate the values
with hyphens. For example, December 5, 2004 is specified 05-12-
2004.
The new time and date are immediately activated on the switch.
Allied Telesyn AT-9448Ts - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Configure System Time
1 - System Time ................... 00:00:00 on 01-Jan-1970
2 - SNTP Status ................... Disabled
3 - SNTP Server ................... 0.0.0.0
4 - UTC Offset .................... +0
5 - Daylight Savings Time (DST) ... Enabled
6 - Poll Interval ................. 600 seconds
7 - Last Delta .................... +0 seconds
U - Update System Time
R - Return to Previous Menu
Enter your selection?