Allied Telesis AT-S63 - Manual (Page 536)

Chapter 22: Spanning Tree and Rapid Spanning Tree Protocols
536 Section V: Spanning Tree Protocols
Configuring RSTP
This section contains the following procedures:
ˆ ”Configuring RSTP Bridge Settings”, next
ˆ “Configuring RSTP Port Settings” on page 539
ˆ “Displaying the RSTP Port Configuration” on page 541
ˆ “Displaying the RSTP Port State” on page 543
ˆ “Resetting RSTP to the Default Settings” on page 544
Configuring
RSTP Bridge
Settings
This section contains the procedure for configuring a bridge’s RSTP
settings.
Caution
The default RSTP parameters are adequate for most networks.
Changing them without prior experience and an understanding of
how RSTP works might have a negative effect on your network. You
should consult the IEEE 802.1w standard before changing any of
the RSTP parameters.
To configure the RSTP bridge settings, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 170 on
page 527.