Allied Telesis AT-S63 - Manual (Page 432)

Chapter 21: SNMPv3
432 Section IV: SNMPv3
Configuring the SNMPv3 View Table
This section contains a description of the SNMPv3 View Table and how to
create, delete, and modify table entries. Creating this table, allows you to
specify a view using the following parameters:
ˆ Subtree OID
ˆ Subtree Mask
ˆ MIB OID Table View
To configure the SNMPv3 View Table, you need to be very familiar with
the OID table. You can be very specific about the view a user can or
cannot access—down to a column or row of the table. AT-S63 supports
the Internet subtree of the OID table.
There are three functions you can perform with the SNMPv3 User Table:
ˆ “Creating an SNMPv3 View Table Entry,” next
ˆ “Deleting an SNMPv3 View Table Entry” on page 435
ˆ “Modifying an SNMPv3 View Table Entry” on page 436
Creating an
SNMPv3 View
Table Entry
To create an entry in the SNMPv3 View Table, perform the following
procedure.
1. Follow steps 1 through 5 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 422. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table menu is shown in Figure 140 on page
423.
2. From the Configure SNMPv3 Table menu, type 3 to select Configure
SNMPv3 View Table.