Configuring stp, Configuring stp bridge settings – Allied Telesis AT-S63 User Manual
Page 529
AT-S63 Management Software Menus Interface User’s Guide
Section V: Spanning Tree Protocols
529
Configuring STP
This section contains the following procedures:
”Configuring STP Bridge Settings”, next
“Configuring STP Port Settings” on page 532
“Displaying STP Port Settings” on page 533
“Resetting STP to the Default Settings” on page 535
Configuring STP
Bridge Settings
This section contains the procedure for configuring a bridge’s STP
settings.
Caution
The default STP parameters are adequate for most networks.
Changing them without prior experience and an understanding of
how STP works might have a negative effect on your network. You
should consult the IEEE 802.1d standard before changing any of the
STP parameters.
To configure the bridge settings, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 170 on
page 527.