Allied Telesis AT-S63 - Manual (Page 749)

AT-S63 Management Software Menus Interface User’s Guide
Section VIII: Port Security 749
5 - Reauth Enabled
Specifies if reauthentication should occur according to the
reauthentication period. The options are Enabled or Disabled. If
disabled, the supplicant is not require to reauthenticate after the initial
authentication.
6 - Reauth Period
Specifies the time period in seconds between reauthentications of the
client when the Reauth. Enabled option is set to Enabled. The default
value is 3600 seconds. The range is 1 to 65,535 seconds.
7 - Supplicant Timeout
This parameter sets the switch-to-client retransmission time for the
EAP-request frame. The default value for this parameter is 30
seconds. The range is 1 to 600 seconds.
8 - Server Timeout
This parameter sets the timer used by the switch to determine
authentication server timeout conditions. The default value for this
parameter is 30 seconds. The range is 1 to 600 seconds.
9 - Max Requests
This parameter specifies the maximum number of times that the switch
retransmits an EAP Request packet to the client before it times out the
authentication session. The default value for this parameter is 2
retransmissions. The range is 1 to 10 retransmissions.
A - VLAN Assignment
This parameter controls whether an authenticator port uses the VLAN
assignments returned by a RADIUS server. Options are:
ˆ Enabled: Specifies that the authenticator port is to use the VLAN
assignment returned by the RADIUS server when a supplicant logs
on. This is the default setting. The port automatically moves to the
designated VLAN after the supplicant successfully logs on.
ˆ Disabled: Specifies that the authenticator port ignore any VLAN
assignment information returned by the RADIUS server when a
supplicant logs on. The authenticator port remains in its predefined
VLAN assignment even if the RADIUS server returns a VLAN
assignment when a supplicant logs on. This is the default setting.
For additional information, refer to “Supplicant and VLAN Associations”
on page 735.
B - Secure VLAN
This parameter controls the action of an authenticator port to
subsequent authentications after the initial authentication where VLAN
assignments have been added to the user accounts on the RADIUS
server. This parameter only applies when the port is operating in the
Multiple operating mode. Possible settings are: