Allied Telesis AT-S63 - Manual (Page 51)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Operations 51
2. If you do create interfaces on a slave switch and designate a local
interface, the local interface must be applied to the common VLAN that
connects the slave switch to the enhanced stack.
3. To remotely manage a slave switch, start the session on the master
switch by specifying the IP address of the local interface on the master
switch and then transition to the slave switch using the enhanced
stacking feature in the AT-S63 management software.
Although the AT-9408LC/SP, AT-9424T/GB, and AT-9424T/SP switches
do not support Layer 3 routing, they do allow you to create one interface
and designate it as the local interface to support those management
functions that require an IP address, such as remote management.
The menus interface supports only routing interfaces. To configure the
static routes and RIP, you must use the command line interface.
For background information on routing interfaces, static routes, and RIP,
refer to Chapter 32, “Internet Protocol Version 4 Packet Routing,” in the
AT-S63 Management Software Command Line Interface User’s Guide.
For background information on enhanced stacking, refer to “Enhanced
Stacking Overview” on page 90. For background information on virtual
LANs, refer to “VLAN Overview” on page 590.