Chapter 29, Internet protocol version 4 routing interfaces – Allied Telesis AT-S63 User Manual
Page 697
Section VII: Internet Protocol Routing
697
Chapter 29
Internet Protocol Version 4 Routing
Interfaces
This chapter contains the following procedures for managing Internet
Protocol Version 4 (IPv4) routing interfaces:
“Creating a New Routing Interface” on page 698
“Modifying a Routing Interface” on page 701
“Deleting a Routing Interface” on page 704
“Displaying the IP Address of the Local Interface” on page 705
“Setting the Default Route or Default Gateway” on page 707
“Setting the Local Interface” on page 708
“Setting the ARP Cache Timeout” on page 709
Note
The IPv4 packet routing feature consists of three components —
routing interfaces, static routes, and the Router Information Protocol
(RIP). The menus interface supports just routing interfaces. Refer to
Chapter 32, “Internet Protocol Version 4 Packet Routing,” in the
AT-S63 Management Software Command Line Interface User’s
Guide for an overview of the IPv4 routing feature and the commands
for managing all of the routing elements.