Allied Telesis AT-S63 - Manual (Page 702)

Chapter 29: Internet Protocol Version 4 Routing Interfaces
702 Section VII: Internet Protocol Routing
The specifications of the interface are displayed in the Modify Interface
menu. An example is shown in Figure 237.
Figure 238. Modify Interface Menu
6. To change the IP address of the interface, type 2 to select IP address.
The following prompt is displayed:
Enter IP Address [STATIC IP|DHCP|BOOTP]:
7. Enter a new static IP address for the interface or enter “DHCP” or
“BOOTP” to activate the DHCP or BOOTP client.
Note
Skip steps 8 and 9 if you selected DHCP or BOOTP in step 7.
8. To change the subnet mask of a static IP address, type 3 to select
Subnet Mask.
The following prompt is displayed:
Enter Subnet Mask:
9. Enter a new subnet mask for the static address of the interface. The
default values are:
Class A address - 255.0.0.0
Class B address - 255.255.0.0
Class C address - 255.255.255.0
The three values listed above are the only supported values because
the value of a byte in a mask must be either 255 or 0.
Allied Telesyn AT-9448Ts - AT-S63
Marketing
User: Manager 11:20:02 02-Jun-2006
Modify Interface
1 - Interface Name .................. VLAN2-0
2 - IP Address ...................... 149.55.22.21
3 - Subnet Mask ..................... 255.255.255.0
M - Modify Interface
R - Return to Previous Menu
Enter your selection?